Babelson Audio BaB Drive v1.2.0-R2R
BaB Drive simulates the sound of analog tape and the classic tubes (triode, tetrode) in most of the popular DAWs
Drive A changes the signal's fundamental frequencies so when it's on CW the signal will be distorted(Bias).
Drive B will make an equal (operating level) and even&odd harmonics. Should you want to add more depth, warmth and presence turn CW the Drive A.
The Amount switch will attenuate the warmth.
======
* iLok driver is not required to run.
* Our release loads faster and uses less memory than original.
VST2 version is not officially supported, but binary has VSTPluginMain
export and specific interface. Install VST2 only if your host does not
support VST3 or problem with VST3 version.
======
https://babelson.com/shop/bab-drive/
本帖最后由 jchenflute 于 20-2-29 04:06 编辑
Drive A changes the signal's fundamental frequencies so when it's on CW the signal will be distorted(Bias).
Drive B will make an equal (operating level) and even&odd harmonics. Should you want to add more depth, warmth and presence turn CW the Drive A.
The Amount switch will attenuate the warmth.
======
* iLok driver is not required to run.
* Our release loads faster and uses less memory than original.
VST2 version is not officially supported, but binary has VSTPluginMain
export and specific interface. Install VST2 only if your host does not
support VST3 or problem with VST3 version.
======
https://babelson.com/shop/bab-drive/
本帖最后由 jchenflute 于 20-2-29 04:06 编辑
