以前自己的帖子複製就直接複製過來了
声音很好 4轨 24bit48khz 跟很多硬盘录音机的音质已经一样了
配合sounddevices442的4路直接输出 你自己不用带录音机也可以了机身上面4个TA3M的input头 自己没有ta3到xlr的转换线的话比较麻烦
最好让器材公司提供 国内TA3的头很难买到 国产的质量都很差
还有一个TA5M的output 这几根线都是 必需会用到的 拍摄之前一定要确认好菜单里可以调line input or mic input
timecode的东西一直没有测试到 因为没有smart slate.....国内用电子板的还是少 本来后面有个电视电影会用的 结果黄掉了 胸闷
red现在的系统是build17,对录音来说,最大的问题就是linein的大小在系统里只有两个选项,一个0dB,一个+10dB,所以一般调音台或者录音机的输入直接给过去的话,input的信号会很大,不衰减的话基本大声级的信号进机器了就peak,我现在用的是SD788T,output过去的信号我衰减了20dB,才基本符合red的动态范围,国外也有很多论坛都讨论到这个,red公司的技术人员也说会在下一次升级,build18的时候会对audio input这块做出调整。
下面是我朋友的建议,他也是衰减了25dB
If the camera is running build 17 there is some ability to adjusttheline level input gain. If it is anything below build 17 then youcannotadjust the line level input. With Jeffery's camera (runningbuild 17) wewere able to adjust the line level input gain but evenwith it set toits lowest setting the level was still quite high.
Here's what I did...
For our shoot I was using a 744T, with a timecode slate. I wasrunningan XLR out of one of the outputs to a single channel on thered. Thiswas just a mixed signal of all four tracks that could be usedforreference during daily screening, or playback. The signal was sohigh,that I had to drop the 744T output level 25dB. This worked justfine forthis situation.
所以用red的话,最好还是双系统来录,录音机为主,red为辅助,台子或者录音机不能衰减master output level的话,就一定要用录音机了
最近我朋友又用他的red的做了測試 說是台子直接送tone到red 就line in 0 dB input,然後final cut pro裡面看 就是在-20的地方 你要是拍攝的話提前自己可以測試一下就好 有錄音機還是推薦錄音機做備份 沒錄音機就提前自己測試好