Sawstudio

set bridge height:
check your string height , using the six inch ruler , and make the necessary adjustments . the recommended string clearance at the 17th fret (measured by the distance between the bottom of the string and the top of the fret ) is :

bass : string 1---4 :3/32" (2mm) +/- 1/64" (.4mm)

these dimensions are the factory recommended setting only . the optimum height adjustment varies from player to player due to differences in technique , playing styles , string gauges , ect.

deluxe fine tuning----
each saddle is individually adjusted by using the .050" Allen wrench to turn the two Allen socket screws located on the top of the saddle . clockwise raises and counterclockwise lowers . be sure both height adjustment screws of eack bridge saddle rest firmly against the bridge plate . also be sure each saddle is parallel to the bridge plate after adjustment.

翻譯這個要對結他類 (假設是結他) 熟識比較好, 小弟這方面不太熟, 故先找了張圖看看

[ 本帖最后由 himhui 于 2006-1-4 18:34 编辑 ]

設置 bridge 的高度:-
用 "六吋量呎(6 inch ruler)" 檢查弦之高度, 建議第17格版面與第1-4弦各的距離(string clearance)為 2mm , 正負不得超過 0.4mm。以上只是廠商的建議, 實際還要因應個人的演奏技術, 風格 和 不同的弦線作決定。

每一個saddle可分別以0.050(吋)的"L形扳手起子(Allen wrench) "調校在saddle上的兩個螺絲位置, 順時鍾方向為升起, 反時鍾方向為降低, 確定螺絲 固定了 bridge plate (bridge的碟子), 以及saddle和bridge plate 能夠保持平衡。

[ 本帖最后由 himhui 于 2006-1-4 20:05 编辑 ]

牛啊!!!佩服你啊!呵呵..厉害

太感谢斑竹了，非常感谢