SAWSTUDIO 免費訊號開關 (talkback)插件
The FREE SignalSwitch plugin from RML Labs.
A wonderful utility that allows you to create a talkback channel on the SAWStudio virtual console. Plug any microphone into the system and assign it through a virtual console channel in Live Mode, then patch this plugin in the Pre-Patch point.
The plugin will block the signal until the large switch is clicked and held with the mouse. You can also latch the switch if desired. It displays a meter showing signal levels when active.
This is the perfect solution for the virtual recording session giving you a talkback mic assignable to any or all of the Aux Sends for headphone monitoring to the performers. Any mic can be used, including condenser mics with no regard for special switching hardware to mute the mic signal without interfering with the phantom power.
You can also use a Gameport or an inexpensive USB-Gameport adaptor and hook up two footswitches or desktop switches to control the plugin from. Perfect for giving the producer his own talkback switch for communication during the session. You can even patch it in two separate channels and use a separate mic for the engineer and producer at the producer’s desk, each with their own physical switch if desired.
[ 本帖最后由 himhui 于 2006-9-18 01:09 编辑 ]
A wonderful utility that allows you to create a talkback channel on the SAWStudio virtual console. Plug any microphone into the system and assign it through a virtual console channel in Live Mode, then patch this plugin in the Pre-Patch point.
The plugin will block the signal until the large switch is clicked and held with the mouse. You can also latch the switch if desired. It displays a meter showing signal levels when active.
This is the perfect solution for the virtual recording session giving you a talkback mic assignable to any or all of the Aux Sends for headphone monitoring to the performers. Any mic can be used, including condenser mics with no regard for special switching hardware to mute the mic signal without interfering with the phantom power.
You can also use a Gameport or an inexpensive USB-Gameport adaptor and hook up two footswitches or desktop switches to control the plugin from. Perfect for giving the producer his own talkback switch for communication during the session. You can even patch it in two separate channels and use a separate mic for the engineer and producer at the producer’s desk, each with their own physical switch if desired.
[ 本帖最后由 himhui 于 2006-9-18 01:09 编辑 ]
研究一下
