合成器/采样器/音源/音色

求助各位大佬：新买的MIDI键盘，在Kontakt的MIDI通道中只有选择omni才响，怎么让他设置成在[A]1通道中可以使用？

本帖最后由 liu583124785 于 23-4-2 15:10 编辑

用 Korg nanoKEY2 及 Roland A49 的路过,   到 Korg 网站下载 设定软体,  
安装后，可任意更改 Midi 键盘 / 控制器 用那一个 Channel.

Roland A49 不用设定软体的,   只要在 Midi 键盘弄几个键便可. 本帖最后由 ccb 于 23-4-2 16:44 编辑

PDF 的 第9页.


MIDI data from the keyboard can be sent on any of 16 MIDI Channels. However, certain MIDIdevices and MIDI software applications require the keyboard to send data on a specified
channel. If this is the case, you can change the channel the data is sent using the following
method:

1. Press the Advanced button to engage Edit Mode.
2. Press one of the 16 Channel keys (D1 to E3), according to the Channel that you need.

For example, if a device specifies that you need to send data on Channel 10, press the
Advanced button, and select Channel 10.
The Channel can also be assigned to the Octave “+” and “-” buttons by doing the following:
1. Press the Advanced button to engage Edit Mode.
2. Press the black key labeled “CHANNEL”.
3. Press the “+” or “-” button to increase or decrease the channel incrementally. When
Channel 16 is reached and “+” is pressed, Channel 1 will be selected. Pressing both the
“+” and “-” buttons together will reset to Channel 1.
本帖最后由 ccb 于 23-4-2 16:44 编辑

学习了

感谢！学习了

这需要设置Midi键盘，让它默认在Channel 01。
3楼可以解决你的问题。

感谢，已经按照他的方法解决了

解决了就好