Sawstudio

画线可以用f键代替，跟画线差不多了

请教，f键是啥？

F就是直接调用SAW预制好的淡入淡出。不过我想这个还不能满足K哥的要求。

不是啊
f是automation渐变，相当于画线了。

比如说已经在automation中设定：在10秒处是-20db，20秒处是-10db
在十秒处按F，则从10秒到20秒就为-20db至-10db渐变

至于其他比如send量，pan。saw支持automation的fx等等，都可以在auto状态通过按v依次写成渐变

還可選區, 選區的首個時間是改動的參數, 選區的尾部時間是原本選區前的參數。

看来真是好多人因为automation的问题而放弃saw了呢...

很多插件效果器支持用midi控制器改变参数，我考虑同步一个cake walk来画线...

是不是很变态...

其實都只是習慣的問題, 在MT軌道自動模式就可以用鍵盤的 "← →"便可移轉指針位置, " < >" 便可加減推子的音量, 每一單位為 0.25db, 絕對準確和有效率 。大家也不妨再加上 slope 的參數,  如"5000-10000ms 作 fade out, 相信試了以後再不會留戀包絡線了。

[ 本帖最后由 himhui 于 2006-9-21 10:59 编辑 ]

这是我不能全面使用saw的唯一原因

..没有线还是不行..

而且查看包络要切换窗口，弄成一体不好么...

以下是bob L 對 AUTOMATION設計的一些原因, 這麼多年來, 他放棄了很多舊有的概念, 並沒有回頭 一看, 但對於一些他認為重要的, 他仍是堅持著.....


The idea that the automation is designed as is, is a huge feature in my opinion.... this is realtime streaming automation that can emulate thousands of random curve shapes, created by you in realtime if desired.

As for editing... its extremely easy to mark and grab and slide and stretch and shrink and pull apart the entries in groups or one entry at a time...
You can also write a fade with one entry and a slope value if you desire...

You can also create complex fade curve shapes and save them in the Automation Gallery and use them again anywhere and anytime.

The current automation design is what allows SAWStudio to emulate true analog fader moves and complex mixed automation of many controls at the same time. Also learn about how the automation filter works... and the use of the F key command for creating smooth ramps of any console control.

There is a lot of power built into the automation as it is currently designed and I would suggest exploring it for a while longer before wishing it to be different.  

Bob L

说实话，我觉得这是bob的失误，无论他是什么样的想法，都不应该给大家的操作带来麻烦

呵呵 其实这个习惯了 做音量包络很方便 同时也可以做的很细我一直用他再配合选区加 F

其实你只要放大以后,也能做得非常仔细的~