试把W2K设置成“标准PC机”手动设定win2000的IRQ。
下文件原是英文，重点的地方我用中文结合实际操作进行注解，由于英文水平差，出错请谅解。
之前說過用StandardPC安裝win2k或如下
Split IRQ_s in Windows 2000 and here is how. Thanks to KUK and Dulanic
from over at AnandTech_s Forums.
Go to Control panel / System / Hardware.
到“控制面板/系统/硬件”
Click on "Device Manager".
点击“设备管理”
Double click "Computer", then right click "Advanced Configuration".
双击“计算机“，击右键“高级配置”
Go to Driver, then click on "update driver".
“升级驱动”
Click next.
Select "Display a list".
“显示列表”
Wait.
Click on "Show all hardware...".
“显示所有硬件”
Select Standard PC.
选择 Standard PC（标准PC）
Now just follow the steps. After you reboot, all your hardware will be
重新启动计算机，将重新扫描并发现所有硬件
re-scanned and assigned separate IRQ_s.
IRQ将按主板的设置工作。
Changing to a Standard PC in control panel will give you the "It is now safe
to turn-off your computer" and the PC won_t shut down automatically anymore.
So here is how you fix that.
这时计算机将无法用软关机的功能，如要软关机，请进行如下修正。
Open up Device manager...
打开“设备管理”
Go to view... show hidden devices.
到菜单的“查看”＞“显示隐藏的设备”
Open up Non-Plug and Play Devices...
Find Microsoft ACPI Driver... DON_T disable or uninstall because that doesn_
t work.
找到“Microsoft ACPI Driver”击右键，单击“停用”
确定并启动计算机
Go into Properties... then driver....
there is a pull down menu to tell windows when to start this driver...
Set it Disabled.... and then reboot
Now go back into it.... the driver will still be there and that_s ok... go
back into properties and where it says status make sure it says Unavailable.
After that you need to install a new driver... manually by using "Add/Remove
Hardware".
到“控制面板/添加删除硬件”＞“添加新设备”＞“否，我从列表选择硬件”
选择“NT APM/Legacy 支持”
硬件安装完结后启动计算机，能软关机了。
Go in and add NT APM/Legacy Support...
It will install something called NT APM/Legacy Interface Node....
Reboot and everything should be all good.
BTW you cannot install the NT APM/Legacy if the Microsoft APCI driver is
running.
如你是重新安装W2K，请在BIOS中的电源管理中把“ACPI Function”关闭，然后安装W2K。
这时你的计算机不能软关机，请按下面设置。
“控制面板/系统/硬件/设备管理”
菜单的“查看”＞“显示隐藏的设备”
双击“NT APM/Legacy 支持”
单击“NT APM/Legacy Interface Node”右键“属性/设备用法”中选择“使用这个设备（启用）”
确定并启动计算。
:rolleyes: :cool: :p