Babelson Audio FD3N USA Edition v1.1.1-R2R
FD1N and FD3N Tube EQ & Saturator plug-ins
While all three EQs / saturators look almost the same, aside from their colours, Babelson Audio says that they use different algorithms. The FD1N is nicknamed “British Edition”, while the FD3N carries the label “U.S.A. Edition”. It doesn’t appear that the EQs have been modeled after any specific British or American pieces of hardware, but Babelson Audio does mention some components that were used for the models
FD1N British Edition: EF86 high gain valve, EZ80 rectifier valve
FD3N U.S.A. Edition: 12AX7 tube, “classic tube”, “warm tube”, “Class A tube”, “vintage tube”, “dirty vintage tube”
======
* iLok driver is not required to run.
* Our release loads faster and uses less memory than original.
VST2 version is not officially supported, but binary has VSTPluginMain
export and specific interface. Install VST2 only if your host does not
support VST3 or problem with VST3 version.
======
https://babelson.com/shop/fd3n/
本帖最后由 jchenflute 于 20-2-29 04:07 编辑
While all three EQs / saturators look almost the same, aside from their colours, Babelson Audio says that they use different algorithms. The FD1N is nicknamed “British Edition”, while the FD3N carries the label “U.S.A. Edition”. It doesn’t appear that the EQs have been modeled after any specific British or American pieces of hardware, but Babelson Audio does mention some components that were used for the models
FD1N British Edition: EF86 high gain valve, EZ80 rectifier valve
FD3N U.S.A. Edition: 12AX7 tube, “classic tube”, “warm tube”, “Class A tube”, “vintage tube”, “dirty vintage tube”
======
* iLok driver is not required to run.
* Our release loads faster and uses less memory than original.
VST2 version is not officially supported, but binary has VSTPluginMain
export and specific interface. Install VST2 only if your host does not
support VST3 or problem with VST3 version.
======
https://babelson.com/shop/fd3n/
本帖最后由 jchenflute 于 20-2-29 04:07 编辑
